Views:0 Author:Site Editor Publish Time: 2016-05-31 Origin:Site
Woodworking engraving machine installation instructions (use wood engraving machine worker reading, enhance safety awareness)
1, wood engraving machine installation environment must meet the work requirements of the computer.
2, the power supply must have a good grounding (ground must have), otherwise, it will be well connected to chassis ground conductors (such as: water pipes, heating pipes, metal doors, install their own ground, etc.)
3, Power Protection: Power repeat interval of not less than 30 seconds.
4, the operating voltage must be between 210V-230V, if the voltage does not comply, then the power supply must be used. Right (power 2000W above, the general weight should be 15 kg or more).
5, the spindle motor protection: If the situation or the motor speed of the motor is stopped carving unevenness occurs, turn off the power immediately and contact your dealer maintenance. If in the case of motor stall the motor is not powered, otherwise the motor via the ring immediately burned, please pay attention to certain users.
6, using the spindle motor: engraving machine carving motor warranty for one year, we used to engrave the motor frequency conversion water-cooled motor, high value, so be sure to pay attention to the correct use of the motor. Motor speed and is inversely proportional to its life. When the motor is running must ensure that the water cycle, and add appropriate amount of preservative, pay attention to the parameters available on the motor use reference manual selection.
7, the protection chuck: chuck between the motor and the tool is fixed by friction of metal, so the installation tool refueling, do not remove or prevent prolonged coolant corrosion caused difficult to remove.
8, must pay attention to safe operation; engraving machine is a mechanical processing equipment, machine tools should be operational requirements to operate, can not wear gloves, can not touch the engraving machine is more professional equipment, if such failure promptly contact your dealer, only in the case of the consent of the dealer permission only for a professional repair.
9, can not add coolant when cutting: when cutting knife with a column (of wood, plexiglass, snow floating panels, etc.), plus coolant will seriously affect the spit crumbs cutting tool breakage caused by the discharge.
10, the fan maintenance: regular cleaning fan dust.
11, pay attention to maintenance: in the course of maintenance engraving machine must be strengthened in order to try to extend the life of the engraving machine. In the engraving machine after each use later, be sure to pay attention to the engraving machine cleaned, put oil on the rail, in order to avoid the machine by environmental corrosion, because the force carved engraving machine with a self-lubricating wear-resistant screw, so use only need a quarter plus lubricant.